| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: don't offload TC setup on AP_VLAN interfaces
AP_VLAN interfaces are purely virtual, so don't try to offload
TC setup to drivers. We can't really use the AP interface either
since we may not know it all the time, and it could technically
even change.
Just reject the TC offload so things get done in software. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Fix out-of-bounds read of sk_protocol in bpf_sock_destroy()
sk_protocol lives in struct sock, not in struct sock_common. A timewait
or request sock handed to bpf_sock_destroy() by the tcp iterator is
neither, so reading sk->sk_protocol runs past the object:
==================================================================
BUG: KASAN: slab-out-of-bounds in bpf_sock_destroy+0xc7/0xe0
Read of size 2 at addr ffff8881047d11b4 by task test_progs/428
Tainted: [W]=WARN
Call Trace:
<TASK>
dump_stack_lvl+0x91/0xf0
print_report+0xd1/0x630
kasan_report+0xf3/0x130
__asan_report_load2_noabort+0x14/0x30
bpf_sock_destroy+0xc7/0xe0
bpf_prog_c3dd61f9d9cd9f37_iter_tcp6_timewait+0x9f/0xb7
bpf_iter_run_prog+0x538/0xde0
bpf_iter_tcp_seq_show+0x26b/0x4b0
bpf_seq_read+0x424/0x1210
vfs_read+0x197/0xe40
ksys_read+0x119/0x240
__x64_sys_read+0x72/0xc0
x64_sys_call+0x647/0x27e0
do_syscall_64+0xe5/0x610
entry_SYSCALL_64_after_hwframe+0x76/0x7e
Only check sk_protocol on full socks. tcp_abort() already knows how to
deal with TIME_WAIT and NEW_SYN_RECV socks. Also fix the comment, it
never matched the code. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: libipw: reject too-short association responses
libipw_handle_assoc_resp() reads the capability, status and aid fields
of the 30-byte association response prefix and then computes the
information element length as
stats->len - sizeof(*frame)
stats->len is a u16 and sizeof() has type size_t, so the subtraction is
evaluated as size_t and wraps instead of going negative. Truncating
that to the u16 length parameter of libipw_parse_info_param() turns a
frame shorter than the fixed fields into a length near 64 KiB, and the
parser then reads past the receive buffer.
Both the ipw2100 and ipw2200 management receive paths reach this
function having established only that the frame carries the generic
24-byte three-address header.
Reject the frame before any fixed field is touched.
Found by an AI-assisted review of length arithmetic in management frame
parsers. Verified with a KUnit case under Generic KASAN on arm64 under
QEMU; I do not have the hardware, so it is not tested on a real device. |
| Dislocker through 0.7.3 contains a heap out-of-bounds read vulnerability in get_dataset() and get_next_datum() that never validate dataset and datum sizes against the metadata allocation. Attackers can craft a BitLocker volume image with inflated dataset or datum sizes that, when opened or mounted, crashes dislocker or discloses adjacent heap memory. |
| A heap-based buffer overflow flaw was found in Cyrus SASL. The add_to_challenge() function in the DIGEST-MD5 plugin computes the size of the buffer needed for a challenge/response field before DIGEST-MD5 quoting is applied, but does not recompute that size when quoting (escaping special characters) makes the value longer. The under-sized buffer is then passed to strcat(), causing a heap-based out-of-bounds write whose size depends on attacker-controlled input. A malicious or on-path DIGEST-MD5 (or HTTP Digest) server can trigger this flaw in a connecting client by supplying a crafted challenge field, such as realm or nonce, most likely resulting in a crash of the client application. |
| In the Linux kernel, the following vulnerability has been resolved:
KEYS: trusted: Fix tpm2_load_cmd() boundary check
tpm2_load_cmd() does boundary checks against the ASN.1 size i.e.,
payload->blob_len. Address this by passing the decoded blob size to
tpm2_load_cmd(), and use it for the boundary checks. |
| An out-of-bounds read vulnerability exists in EIPStackGroup OpENer v2.3 and master through commit 76b95cf in the server-side CIP SetAttributeList service. This allows a remote attacker to cause a denial of service |
| OpENer v2.3/commit 76b95cf, contains an out-of-bounds read in the server-side EtherNet/IP ForwardOpen connection-path parser. This allows a remote attacker to cause a denial of service. |
| An out-of-bounds read vulnerability exists in EIPStackGroup OpENer v2.3 and master up to commit 76b95cf in the EtherNet/IP TCP SendRRData Common Packet Format parser. The issue occurs in CreateCommonPacketFormatStructure() when it parses recognized optional socket address information items of type 0x8000 or 0x8001 without first validating that the remaining CPF buffer contains the complete fixed sockaddr structure. This allows a remote attacker to cause a denial of service. |
| RIOT is an open-source microcontroller operating system designed for Internet of Things devices and other embedded systems. In 2026.07 and earlier, the nanoCoAP client function nanocoap_sock_get_slice() in sys/net/application_layer/nanocoap/sock.c accepts a Block2 response when _block_cb() sees the expected block number without also verifying that the server-controlled szx and derived offset match the requested block geometry. A malicious CoAP server can return the expected block number with a larger block size, causing the derived offset to exceed the client slice offset and making ctx->offset - offset underflow in _2buf_slice(). The resulting buffer-relative calculation can read before the payload buffer and crash the client, causing denial of service and potentially exposing adjacent memory. No fixed release is available as of this review. |
| The LE Audio Broadcast Sink in subsys/bluetooth/audio/bap_broadcast_sink.c copies subgroup metadata from a received Basic Audio Announcement (BASE) into the static Broadcast Audio Scan Service parameter structure mod_src_param without any bounds check. In base_subgroup_meta_cb() the destination element was selected as mod_src_param.subgroups[mod_src_param.num_subgroups] with no test against ARRAY_SIZE(mod_src_param.subgroups) (sized by CONFIG_BT_BAP_BASS_MAX_SUBGROUPS, default 1), and the metadata was copied with memcpy() using the raw on-air length returned by bt_bap_base_get_subgroup_codec_meta() into a metadata array sized by CONFIG_BT_AUDIO_CODEC_CFG_MAX_METADATA_SIZE (default 4). The BASE validator bt_bap_base_get_base_from_ad() only checks structural consistency and permits up to ~24 subgroups and metadata LTVs of ~240 octets.
The defect is reached from the periodic advertising receive callback: pa_recv() → bt_data_parse() → pa_decode_base() → update_recv_state_base() → bt_bap_base_foreach_subgroup() → base_subgroup_meta_cb(). Every broadcast sink registers a scan-delegator receive state at creation (bt_bap_broadcast_sink_create() calls broadcast_sink_add_src()), and CONFIG_BT_BAP_BROADCAST_SINK depends on CONFIG_BT_BAP_SCAN_DELEGATOR, so the path is active in every broadcast-sink build once the device is periodic-advertising-synced. An attacker in radio range who operates a broadcast source the device syncs to — or who impersonates the advertiser address and SID of one already in use, periodic advertising data being unauthenticated — can change the BASE at will; each new BASE is re-parsed.
A crafted BASE therefore writes attacker-chosen bytes past the end of a fixed static object in .bss: up to roughly 236 bytes for an oversized metadata LTV, plus whole struct bt_bap_bass_subgroup records for each subgroup beyond CONFIG_BT_BAP_BASS_MAX_SUBGROUPS. This is memory corruption of adjacent Bluetooth-audio state reachable with no pairing, bonding or GATT connection, with a potential for remote code execution in the Bluetooth RX thread; in addition, the unvalidated metadata_len is forwarded to bt_bap_scan_delegator_mod_src(), which neither clamps it nor rejects it, leading to a further copy into the receive state and to out-of-bounds memory being disclosed in the BASS receive-state notification sent to a connected Broadcast Assistant.
The fix rejects a BASE carrying more subgroups than the receive state can hold (discarding the update entirely) and omits metadata that does not fit rather than copying it, and additionally honours the previously-ignored error return of the subgroup decode pass. |
| Incorrect Authorization vulnerability in ash-project ash allows an actor to infer data in related records they cannot read via Ash.count/2, Ash.exists/2 and Ash.aggregate/3.
Ash.Actions.Aggregate.run/4 (lib/ash/actions/aggregate.ex) applied only the root resource's read policy before running the aggregate query. The read path also applies each related resource's read policy to filter and sort references that cross a relationship, directly (for example comments.body) or through an aggregate over one, but the aggregate path skipped that step. A caller whose filter or sort reaches these functions, for example through Ash.Query.filter_input/2, an ash_lua script, or an AshAi tool offering count or exists results, can test conditions against related rows hidden from them and recover their existence and attribute values one query at a time. Ash.read/2 and its page counts are not affected.
This issue affects ash: from 2.6.0 before 3.34.6. |
| In Modem, there is a possible out of bounds read due to a missing permission check. This could lead to remote denial of service, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01774038; Issue ID: MSV-8911. |
| In Modem, there is a possible out of bounds read due to a missing bounds check. This could lead to remote denial of service, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01774038; Issue ID: MSV-8912. |
| In Modem, there is a possible out of bounds read due to a missing bounds check. This could lead to remote denial of service, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01774038; Issue ID: MSV-8913. |
| In Modem, there is a possible out of bounds read due to a missing permission check. This could lead to remote denial of service, if a UE has connected to a rogue base station controlled by the attacker, with no additional execution privileges needed. User interaction is not needed for exploitation. Patch ID: MOLY01774038; Issue ID: MSV-8914. |
| The Affinity by Canva application for macOS before 3.3.1 (October 2026 release) did not safely calculate the size of an image buffer when generating QuickLook thumbnails and previews of Affinity document files, leading to an integer overflow and a heap-based buffer overflow. A threat actor could craft an Affinity document that, when displayed or previewed by a user in Finder, could corrupt heap memory and cause the thumbnail or preview extension to crash. |
| The Affinity by Canva app for macOS before 3.3.1 (October 2026 release) did not perform adequate bounds checking when generating QuickLook thumbnails and previews of Affinity document files, leading to an out-of-bounds heap read. A threat actor could craft an Affinity document that, when displayed or previewed by a user in Finder, could disclose the contents of adjacent heap memory, including memory addresses, in the rendered thumbnail or preview image. |
| The Affinity by Canva application for macOS before 3.3.1 (October 2026 release) did not validate image dimensions against the size of the pixel data when generating QuickLook thumbnails and previews of Affinity document files, leading to an out-of-bounds heap read. A threat actor could craft an Affinity document that, when displayed or previewed by a user in Finder, could disclose the contents of adjacent heap memory in the rendered thumbnail or preview image, or cause the thumbnail or preview extension to crash. |
| A stack-based buffer overflow in the _RdbLoadEntity function of the RDB graph decoders (src/serializers/decoders/*/decode_graph_entities.c) in FalkorDB before 4.18.4 allows a remote attacker who can issue Redis replication commands (for example, against an instance with no password configured) to cause a denial of service and possibly execute arbitrary code by supplying a crafted RDB stream with an attacker-controlled entity property count. The count sizes two variable-length arrays on the thread stack with no upper bound, and the decoder then fills them with attacker-supplied values. |
