| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the activation of an access control list (ACL) on Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass the protection that is offered by a configured ACL on an affected device. This vulnerability is due to a logic error that occurs when an ACL changes from inactive to active in the running configuration of an affected device. An attacker could exploit this vulnerability by sending traffic through the affected device that should be denied by the configured ACL. The reverse condition is also true—traffic that should be permitted could be denied by the configured ACL. A successful exploit could allow the attacker to bypass configured ACL protections on the affected device, allowing the attacker to access trusted networks that the device might be protecting. Note: This vulnerability applies to both IPv4 and IPv6 traffic as well as dual-stack ACL configurations in which both IPv4 and IPv6 ACLs are configured on an interface. |
| A vulnerability in the remote access VPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper handling of HTTPS requests. An attacker could exploit this vulnerability by sending crafted HTTPS requests to an affected system. A successful exploit could allow the attacker to cause resource exhaustion, resulting in a DoS condition. |
| A vulnerability in the Internet Key Exchange version 2 (IKEv2) protocol processing of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to insufficient input validation when processing IKEv2 messages. An attacker could exploit this vulnerability by sending crafted IKEv2 traffic to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition on the affected device. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| Multiple vulnerabilities in the Application Layer Protocol Inspection feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerabilities are due to logical errors during traffic inspection. An attacker could exploit these vulnerabilities by sending a high volume of malicious traffic across an affected device. An exploit could allow the attacker to cause a deadlock condition, resulting in a reload of an affected device. These vulnerabilities affect Cisco ASA Software and Cisco FTD Software configured for Application Layer Protocol Inspection running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4100 Series Security Appliance, Firepower 9300 ASA Security Module, FTD Virtual (FTDv). Cisco Bug IDs: CSCve61540, CSCvh23085, CSCvh95456. |
| A vulnerability in the implementation of Security Assertion Markup Language (SAML) 2.0 single sign-on (SSO) for remote access VPN in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to intercept the SAML assertion of a user who is authenticating to a remote access VPN session. This vulnerability is due to insufficient validation of the login URL. An attacker could exploit this vulnerability by persuading a user to access a site that is under the control of the attacker, allowing the attacker to modify the login URL. A successful exploit could allow the attacker to intercept a successful SAML assertion and use that assertion to establish a remote access VPN session toward the affected device with the identity and permissions of the hijacked user, resulting in access to the protected network. |
| A vulnerability in the Secure Sockets Layer (SSL) VPN functionality of the Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to cause a reload of the affected system or to remotely execute code. The vulnerability is due to an attempt to double free a region of memory when the webvpn feature is enabled on the Cisco ASA device. An attacker could exploit this vulnerability by sending multiple, crafted XML packets to a webvpn-configured interface on the affected system. An exploit could allow the attacker to execute arbitrary code and obtain full control of the system, or cause a reload of the affected device. This vulnerability affects Cisco ASA Software that is running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, ASA 1000V Cloud Firewall, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4110 Security Appliance, Firepower 9300 ASA Security Module, Firepower Threat Defense Software (FTD). Cisco Bug IDs: CSCvg35618. |
| A vulnerability in the implementation of SAML 2.0 single sign-on (SSO) for remote access VPN services in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to successfully establish a VPN session on an affected device. This vulnerability is due to improper separation of authorization domains when using SAML authentication. An attacker could exploit this vulnerability by using valid credentials to successfully authenticate using their designated connection profile (tunnel group), intercepting the SAML SSO token that is sent back from the Cisco ASA device, and then submitting the same SAML SSO token to a different tunnel group for authentication. A successful exploit could allow the attacker to establish a remote access VPN session using a connection profile that they are not authorized to use and connect to secured networks behind the affected device that they are not authorized to access. For successful exploitation, the attacker must have valid remote access VPN user credentials. |
| A vulnerability in a legacy capability that allowed for the preloading of VPN clients and plug-ins and that has been available in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to execute arbitrary code with root-level privileges. Administrator-level privileges are required to exploit this vulnerability.
This vulnerability is due to improper validation of a file when it is read from system flash memory. An attacker could exploit this vulnerability by copying a crafted file to the disk0: file system of an affected device. A successful exploit could allow the attacker to execute arbitrary code on the affected device after the next reload of the device, which could alter system behavior. Because the injected code could persist across device reboots, Cisco has raised the Security Impact Rating (SIR) of this advisory from Medium to High. |
| A vulnerability in the cryptographic hardware accelerator driver of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a temporary denial of service (DoS) condition. The vulnerability exists because the affected devices have a limited amount of Direct Memory Access (DMA) memory and the affected software improperly handles resources in low-memory conditions. An attacker could exploit this vulnerability by sending a sustained, high rate of malicious traffic to an affected device to exhaust memory on the device. A successful exploit could allow the attacker to exhaust DMA memory on the affected device, which could cause the device to reload and result in a temporary DoS condition. |
| A vulnerability in the management and VPN web servers for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to incomplete error checking when parsing an HTTP header. An attacker could exploit this vulnerability by sending a crafted HTTP request to a targeted web server on a device. A successful exploit could allow the attacker to cause a DoS condition when the device reloads. |
| A vulnerability in the VPN web client services feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a browser that is accessing an affected device. This vulnerability is due to improper validation of user-supplied input to application endpoints. An attacker could exploit this vulnerability by persuading a user to follow a link designed to submit malicious input to the affected application. A successful exploit could allow the attacker to execute arbitrary HTML or script code in the browser in the context of the web services page. |
| A vulnerability in the SSL VPN feature for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition.
This vulnerability is due to a logic error in memory management when the device is handling SSL VPN connections. An attacker could exploit this vulnerability by sending crafted SSL/TLS packets to the SSL VPN server of the affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in the AnyConnect firewall for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should have been denied to flow through an affected device. This vulnerability is due to a logic error in populating group ACLs when an AnyConnect client establishes a new session toward an affected device. An attacker could exploit this vulnerability by establishing an AnyConnect connection to the affected device. A successful exploit could allow the attacker to bypass configured ACL rules. |
| A vulnerability in the AnyConnect firewall for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should have been denied to flow through an affected device. This vulnerability is due to a logic error in populating group ACLs when an AnyConnect client establishes a new session toward an affected device. An attacker could exploit this vulnerability by establishing an AnyConnect connection to the affected device. A successful exploit could allow the attacker to bypass configured ACL rules. |
| A vulnerability in the SSL/TLS client of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper memory management when a device initiates SSL/TLS connections. An attacker could exploit this vulnerability by ensuring that the device will connect to an SSL/TLS server that is using specific encryption parameters. A successful exploit could allow the attacker to cause the affected device to unexpectedly reload, resulting in a DoS condition. |
| A vulnerability in dynamic access policies (DAP) functionality of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition.
This vulnerability is due to improper processing of HostScan data received from the Posture (HostScan) module. An attacker could exploit this vulnerability by sending crafted HostScan data to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition.
https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-asa-ftd-dap-dos-GhYZBxDU ["https://tools.cisco.com/security/center/content/CiscoSecurityAdvisory/cisco-sa-asa-ftd-dap-dos-GhYZBxDU"]
This advisory is part of the November 2022 release of the Cisco ASA, FTD, and FMC Security Advisory Bundled publication. |
| A vulnerability in the Dynamic Access Policies (DAP) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause an affected device to reload unexpectedly. To exploit this vulnerability, an attacker would need valid remote access VPN user credentials on the affected device.
This vulnerability is due to improper validation of data in HTTPS POST requests. An attacker could exploit this vulnerability by sending a crafted HTTPS POST request to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a denial of service (DoS) condition. |
| A vulnerability in the Simple Network Management Protocol (SNMP) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by sending a crafted SNMP request to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| A vulnerability in the authentication and authorization flows for VPN connections in Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to establish a connection as a different user.
This vulnerability is due to a flaw in the authorization verifications during the VPN authentication flow. An attacker could exploit this vulnerability by sending a crafted packet during a VPN authentication. The attacker must have valid credentials to establish a VPN connection. A successful exploit could allow the attacker to establish a VPN connection with access privileges from a different user. |
