| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
media: venus: hfi: add check to handle incorrect queue size
qsize represents size of shared queued between driver and video
firmware. Firmware can modify this value to an invalid large value. In
such situation, empty_space will be bigger than the space actually
available. Since new_wr_idx is not checked, so the following code will
result in an OOB write.
...
qsize = qhdr->q_size
if (wr_idx >= rd_idx)
empty_space = qsize - (wr_idx - rd_idx)
....
if (new_wr_idx < qsize) {
memcpy(wr_ptr, packet, dwords << 2) --> OOB write
Add check to ensure qsize is within the allocated size while
reading and writing packets into the queue. |
| In the Linux kernel, the following vulnerability has been resolved:
RDMA/cma: Fix workqueue crash in cma_netevent_work_handler
struct rdma_cm_id has member "struct work_struct net_work"
that is reused for enqueuing cma_netevent_work_handler()s
onto cma_wq.
Below crash[1] can occur if more than one call to
cma_netevent_callback() occurs in quick succession,
which further enqueues cma_netevent_work_handler()s for the
same rdma_cm_id, overwriting any previously queued work-item(s)
that was just scheduled to run i.e. there is no guarantee
the queued work item may run between two successive calls
to cma_netevent_callback() and the 2nd INIT_WORK would overwrite
the 1st work item (for the same rdma_cm_id), despite grabbing
id_table_lock during enqueue.
Also drgn analysis [2] indicates the work item was likely overwritten.
Fix this by moving the INIT_WORK() to __rdma_create_id(),
so that it doesn't race with any existing queue_work() or
its worker thread.
[1] Trimmed crash stack:
=============================================
BUG: kernel NULL pointer dereference, address: 0000000000000008
kworker/u256:6 ... 6.12.0-0...
Workqueue: cma_netevent_work_handler [rdma_cm] (rdma_cm)
RIP: 0010:process_one_work+0xba/0x31a
Call Trace:
worker_thread+0x266/0x3a0
kthread+0xcf/0x100
ret_from_fork+0x31/0x50
ret_from_fork_asm+0x1a/0x30
=============================================
[2] drgn crash analysis:
>>> trace = prog.crashed_thread().stack_trace()
>>> trace
(0) crash_setup_regs (./arch/x86/include/asm/kexec.h:111:15)
(1) __crash_kexec (kernel/crash_core.c:122:4)
(2) panic (kernel/panic.c:399:3)
(3) oops_end (arch/x86/kernel/dumpstack.c:382:3)
...
(8) process_one_work (kernel/workqueue.c:3168:2)
(9) process_scheduled_works (kernel/workqueue.c:3310:3)
(10) worker_thread (kernel/workqueue.c:3391:4)
(11) kthread (kernel/kthread.c:389:9)
Line workqueue.c:3168 for this kernel version is in process_one_work():
3168 strscpy(worker->desc, pwq->wq->name, WORKER_DESC_LEN);
>>> trace[8]["work"]
*(struct work_struct *)0xffff92577d0a21d8 = {
.data = (atomic_long_t){
.counter = (s64)536870912, <=== Note
},
.entry = (struct list_head){
.next = (struct list_head *)0xffff924d075924c0,
.prev = (struct list_head *)0xffff924d075924c0,
},
.func = (work_func_t)cma_netevent_work_handler+0x0 = 0xffffffffc2cec280,
}
Suspicion is that pwq is NULL:
>>> trace[8]["pwq"]
(struct pool_workqueue *)<absent>
In process_one_work(), pwq is assigned from:
struct pool_workqueue *pwq = get_work_pwq(work);
and get_work_pwq() is:
static struct pool_workqueue *get_work_pwq(struct work_struct *work)
{
unsigned long data = atomic_long_read(&work->data);
if (data & WORK_STRUCT_PWQ)
return work_struct_pwq(data);
else
return NULL;
}
WORK_STRUCT_PWQ is 0x4:
>>> print(repr(prog['WORK_STRUCT_PWQ']))
Object(prog, 'enum work_flags', value=4)
But work->data is 536870912 which is 0x20000000.
So, get_work_pwq() returns NULL and we crash in process_one_work():
3168 strscpy(worker->desc, pwq->wq->name, WORKER_DESC_LEN);
============================================= |
| In the Linux kernel, the following vulnerability has been resolved:
arm/crc-t10dif: fix use of out-of-scope array in crc_t10dif_arch()
Fix a silly bug where an array was used outside of its scope. |
| In the Linux kernel, the following vulnerability has been resolved:
Input: iforce - invert valid length check when fetching device IDs
syzbot is reporting uninitialized value at iforce_init_device() [1], for
commit 6ac0aec6b0a6 ("Input: iforce - allow callers supply data buffer
when fetching device IDs") is checking that valid length is shorter than
bytes to read. Since iforce_get_id_packet() stores valid length when
returning 0, the caller needs to check that valid length is longer than or
equals to bytes to read. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: Prevent division by zero
The user can set any speed value.
If speed is greater than UINT_MAX/8, division by zero is possible.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: Prevent division by zero
The user can set any speed value.
If speed is greater than UINT_MAX/8, division by zero is possible.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: Prevent division by zero
The user can set any speed value.
If speed is greater than UINT_MAX/8, division by zero is possible.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm/smu11: Prevent division by zero
The user can set any speed value.
If speed is greater than UINT_MAX/8, division by zero is possible.
Found by Linux Verification Center (linuxtesting.org) with SVACE.
(cherry picked from commit da7dc714a8f8e1c9fc33c57cd63583779a3bef71) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: Prevent division by zero
The user can set any speed value.
If speed is greater than UINT_MAX/8, division by zero is possible.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amd/pm: Prevent division by zero
The user can set any speed value.
If speed is greater than UINT_MAX/8, division by zero is possible.
Found by Linux Verification Center (linuxtesting.org) with SVACE. |
| Closing of an event channel in the Linux kernel can result in a deadlock.
This happens when the close is being performed in parallel to an unrelated
Xen console action and the handling of a Xen console interrupt in an
unprivileged guest.
The closing of an event channel is e.g. triggered by removal of a
paravirtual device on the other side. As this action will cause console
messages to be issued on the other side quite often, the chance of
triggering the deadlock is not neglectable.
Note that 32-bit Arm-guests are not affected, as the 32-bit Linux kernel
on Arm doesn't use queued-RW-locks, which are required to trigger the
issue (on Arm32 a waiting writer doesn't block further readers to get
the lock). |
| Bluetooth LE and BR/EDR secure pairing in Bluetooth Core Specification 2.1 through 5.2 may permit a nearby man-in-the-middle attacker to identify the Passkey used during pairing (in the Passkey authentication procedure) by reflection of the public key and the authentication evidence of the initiating device, potentially permitting this attacker to complete authenticated pairing with the responding device using the correct Passkey for the pairing session. The attack methodology determines the Passkey value one bit at a time. |
| In the Linux kernel, the following vulnerability has been resolved:
amdkfd: use calloc instead of kzalloc to avoid integer overflow
This uses calloc instead of doing the multiplication which might
overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
tomoyo: fix UAF write bug in tomoyo_write_control()
Since tomoyo_write_control() updates head->write_buf when write()
of long lines is requested, we need to fetch head->write_buf after
head->io_sem is held. Otherwise, concurrent write() requests can
cause use-after-free-write and double-free problems. |
| In the Linux kernel, the following vulnerability has been resolved:
binder: signal epoll threads of self-work
In (e)poll mode, threads often depend on I/O events to determine when
data is ready for consumption. Within binder, a thread may initiate a
command via BINDER_WRITE_READ without a read buffer and then make use
of epoll_wait() or similar to consume any responses afterwards.
It is then crucial that epoll threads are signaled via wakeup when they
queue their own work. Otherwise, they risk waiting indefinitely for an
event leaving their work unhandled. What is worse, subsequent commands
won't trigger a wakeup either as the thread has pending work. |
| In the Linux kernel, the following vulnerability has been resolved:
Revert "kobject: Remove redundant checks for whether ktype is NULL"
This reverts commit 1b28cb81dab7c1eedc6034206f4e8d644046ad31.
It is reported to cause problems, so revert it for now until the root
cause can be found. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/fpu: Stop relying on userspace for info to fault in xsave buffer
Before this change, the expected size of the user space buffer was
taken from fx_sw->xstate_size. fx_sw->xstate_size can be changed
from user-space, so it is possible construct a sigreturn frame where:
* fx_sw->xstate_size is smaller than the size required by valid bits in
fx_sw->xfeatures.
* user-space unmaps parts of the sigrame fpu buffer so that not all of
the buffer required by xrstor is accessible.
In this case, xrstor tries to restore and accesses the unmapped area
which results in a fault. But fault_in_readable succeeds because buf +
fx_sw->xstate_size is within the still mapped area, so it goes back and
tries xrstor again. It will spin in this loop forever.
Instead, fault in the maximum size which can be touched by XRSTOR (taken
from fpstate->user_size).
[ dhansen: tweak subject / changelog ] |
| In the Linux kernel, the following vulnerability has been resolved:
i2c: i801: Fix block process call transactions
According to the Intel datasheets, software must reset the block
buffer index twice for block process call transactions: once before
writing the outgoing data to the buffer, and once again before
reading the incoming data from the buffer.
The driver is currently missing the second reset, causing the wrong
portion of the block buffer to be read. |
| copy_params in drivers/md/dm-ioctl.c in the Linux kernel through 6.7.1 can attempt to allocate more than INT_MAX bytes, and crash, because of a missing param_kernel->data_size check. This is related to ctl_ioctl. |
| In btrfs_get_root_ref in fs/btrfs/disk-io.c in the Linux kernel through 6.7.1, there can be an assertion failure and crash because a subvolume can be read out too soon after its root item is inserted upon subvolume creation. |
